Fully automated coil transfer hydraulic system engineered to reduce stress through proportionately controlled initial starting and stopping of the transfer walking beam circuit.

Back up roll balance cylinder hydraulic power unit designed to remove blocks from common hydraulic manifold to a “stand alone” circuit; thus, allowing independent pressurizing of blocks to reduce costly repairs and reduce drive bearing premature failures.

Segment clamp hydraulic system 500-gallon piston accumulator stand installed to eliminate the event of slippage during pump regeneration process.

Descale project design & installation of multiple turnkey and replacement systems capable of 6000 psi and flow rates to meet any requirements.

Edge guide hydraulic power units to operate off existing edge measuring units or installation of new feedback components.

Mandrel expand cylinder design and modifications, in addition to construction of completely new rotating cylinders. Converting the rotary unions to a ball bearing and teflon lip design capable to withstand high pressures at higher speeds. This is a process we have implemented in hundreds of applications.

Design and construction of all hydraulic configurations, pressures, and sizes.